Copyright © 2019, Fast ČR, a. s. Revision 07/2020
EN - 20
PART 8: TROUBLE SHOOTING
If you experience a problem with your appliance or are concerned that the appliance is not functioning
correctly, you can carry out some easy checks before calling for service,please see below.
Caution! Don’t try to repair the appliance yourself. If the problem persists after you have made the
checks mentioned below, contact a qualied electrician, authorized service engineer or the shop
where you purchased the product.
Important! There are some sounds during normal use (compressor, refrigerant circulation).
Problem Possible cause Solution
Appliance does not work
Temperature regulation knob is
set at number "0".
Set the knob at other number to
switch on the appliance.
Mains plug is not plugged in or
is loose
Insert mains plug.
Fuse has blown or is defective Check fuse, replace if necessary.
Socket is defective
Mains malfunctions are to be
corrected by an electrician.
The food is too warm.
Temperature is not properly
adjusted.
Please look in the initial
Temperature setting section.
Door was open for an extended
period.
Open the door only as long as
necessary.
A large quantity of warm food
was placed in the appliance
within the last 24 hours.
Turn the temperature regulation
to a colder setting temporarily.
The appliance is near a heat
source.
Please loo# in the installation
location section.
Appliance cools too much Temperature is set too cold.
Turn the temperature regulation
knob to a warmer setting
temporarily.
Unusual noises
Appliance is not level. Re-adjust the feet.
The appliance is touching the
wall or other objects.
Move the appliance slightly.
A component, e.g. a pipe, on the
rear of the appliance is touching
another part of the appliance or
the wall.
If necessary, carefully bend the
component out of the way.
If the malfunction shows again, contact the Service Center.
These data are necessary to help you quickly and correctly. Write the necessary data here, refer to the rating
plate.
To Next Page
