Why does my Philco Washer fill with water when a process is cancelled?
If your Philco Washer fills with water when a process is cancelled, it is because the inside of the machine may be hot. For safety reasons, water should be cycled in and out a couple of times.
Why does my Philco PW709L Washer vibrate so much?
Your Philco Washer may be vibrating or shaking due to several reasons: * The machine feet might need adjustment. * The transportation safety bolts might not have been removed. * There might be a small amount of laundry in the machine, or the machine may be overloaded, or the clothes may be distributed unevenly. * The machine might be touching a solid surface. Ensure that nothing touches the machine.
How to fix water coming from the bottom of my Philco Washer?
If you notice water coming from the bottom of your Philco Washer, the issue might be with the hoses or the pump filter. Ensure the seals of the water inlet hoses are securely fitted. Also, tightly attach the drain hose to the waste pipe or sink, and make sure that the pump filter is completely closed.
What to do if my Philco Washer won't drain water?
If your Philco Washer isn't discharging water, the water outlet hose might be clogged or twisted; clean or straighten it. Additionally, the pump filter may be clogged, so clean the pump filter as well.
Why is there a bad odor coming from my Philco PW709L?
If there is a bad odor coming from your Philco Washer, it may be due to oily accumulations on the drum that have stuck to the laundry. The machine must be operated empty either at 60°C or 90°C program with detergent every 6 months.
Why Philco PW709L Washer program won't start?
If the program on your Philco Washer cannot be started or selected, the machine may have switched to self-protection mode due to an infrastructure problem, such as line voltage or water pressure. Reset your machine by pressing the “Start/Pause/Cancel” button for 3 seconds.
Why is there detergent left on the laundry after washing in my Philco PW709L?
If there is detergent left on the laundry after washing in your Philco Washer, it could be due to: * Excessive laundry might have been loaded in. Do not load the machine in excess. * Wrong program and temperature might have been selected. Select the proper program and temperature for the laundry to be washed. * Wrong detergent may have been used. Use wool detergents for woolen.
Why does my Philco PW709L Washer take longer than expected?
The washing time on your Philco Washer might be longer than specified in the manual due to several factors: * Low water pressure: The machine will wait until there is a sufficient amount of water, which may lengthen the washing time to avoid poor washing results due to insufficient water. * Low supply voltage: Washing time is lengthened to avoid poor washing results when the supply voltage is low. * Low input temperature of water: Cycle time lengthens to heat up the water when the input water is cold. * Imbalance of laundry: The automatic spin correction system might have been activated due to the unbalanced distribution of the laundry in the drum. Laundry should be rearranged and re-spun. * Increased number of rinses or amount of rinse water: Water amount is increased to obtain...
Why is the door of my Philco Washer jammed?
If the door of your Philco Washer is jammed, it could be due to a few reasons: * The water level might be above the lower level of the door. Run either the “Pump” or “Spin” program. * The machine might be heating up the water or it may be at the spinning cycle. Wait until the process is over. * Due to the electrical safety mechanism, the door can only be opened a few minutes after the program has stopped. Wait until the process is over.
Why are there oily stains on my laundry after washing in my Philco PW709L Washer?
If you notice oily stains on your laundry after washing in your Philco Washer, oily accumulations on the drum may have stuck to the laundry. Leave the detergent dispenser drawer as well as the loading door of the machine ajar after each washing. The machine must be operated empty either at 60°C or 90°C program with detergent every 6 months.
To Next Page
General
