2
CONNECT YOUR DEVICE
1. Plug-in the power cord or the PoE ethernet cable.
2. Power up the device, Welcome, select language and Start
Security Setting: Skip
Signage Display settings: Select Manual Setup and Next
Signage Display Name: Skip
Remote Control: Skip
3. Network Settings: Chose and config either Wi-Fi or Ethernet
For the Wi-Fi setting, please go to the Wi-Fi page and switch on
the Wi-Fi button. After the automatic Wi-Fi scan, select your
desired Wi-Fi and enter credentials if necessary.
For Ethernet, the network will automatically connect when you
plug-in the Ethernet cable.
4. Clone Media Files into Internal: Skip
Setup Complete: Finish
5. When the Welcome to Android Display controller appear, press
Power key and volume down at the same time.
6. Enter Password: 1234 (default from factory) and OK
Philips Android Configuration menu
DATE & TIME SETTINGS
1. Tap on the Settings, System, Date & time to change or adjust the
date / time.
2. Make sure the selected time zone is correct for your location.
With Automatic date & time you can set date / time either by network
or set manually. You can select a different time zone by tapping “Select
time zone”.
To Next Page
Loading...
