HUDSON 9
73
1. FOREWORD
This specification describes a 19" SXGA multi-scan color TFT LCD monitor with maximum resolution up to 1440*900
/75 Hz non-interlaced.
All optical characteristics (including WHITE-D, Brightness, and so on) are determined according to panel
specification after warming up approximate 30 minutes that brightness stability is optimal, and follow strictly after
panel specification.
2. PRODUCT PROFILE
This display monitor unit is a color display monitor enclosed in PHILIPS styling cabinet which has an integrated tilt
base.
2.1 LCD
Type NR. : CMO, M190A1-L0A
Outside dimensions : 428.24(w)∗278(h)∗18.5(d) (Typ) mm
Pitch ( mm ) : 0.2835 mm x 0.2835 mm
Color pixel arrangement : RGB vertical stripes
Display surface : low reflection, antiglare with hard coating
Color depth : 16.7 M colors (6 bits + FRC)
Backlight : CCFL edge light system
Active area(WxH) : 408.24 x 255.15mm
View angle (CR>10) : 170/160 (typ)
Contrast ratio : 1000:1
White luminance : Original color 230 nits (Min), 300 nits (Typ.)
Gate IC :
Source IC :
Response time : 5ms (typ)
MTBF :
2.2 Scanning frequencies
Hor. : 30 – 83 K Hz
Ver. : 56 - 76 Hz
Video dot rate : <140 MHz
Power input : 90-264 V AC, 50/60 ± 2 Hz
Power consumption : < 36W ( Typ.) TBD W (MAX.)
Functions:
(1) D-SUB analog R/G/B separate inputs, H/V sync separated, Composite (H+V) TTL level, SOG sync
(2) DVI digital Panel Link TMDS inputs
2.3 Ambient temperature: 0 °C - 40°C
3. Electrical characteristics
3.1 Interface signals
1). D-Sub Analog
Input signal : Video, Hsync., Vsync
Video : 0.7 Vp-p, input impedance, 75 ohm @DC
Sync. : Separate sync TTL level , input impedance 2.2k ohm terminate
Hsync Positive/Negative
Vsync Positive/Negative
Composite sync TTL level, input impedance 2.2k ohm terminate (Positive/Negative)
Sync on green video 0.3 Vp-p Negative (Video 0.7 Vp-p Positive)
2). DVI-D Digital
Input signal: Single TMDS link (Three channels: RX0-/+, RX1-/+, RX2-/+)
3). USB PLUG support
To Next Page
Loading...
