15
Use TV lock
You can prevent your children from watching
certain programs or certain channels by locking
the TV controls.
Set or change the TV lock code
1 Press MENU.
2 Press to select [Features] > [Set
code].
3 Press to enter the code setup.
4 Enter your code using the Numeric
buttons.
5 Re-enter the same code in the new
dialogue box for confirmation.
If the code is set successfully, the »
dialogue box will disappear. However, if
the code cannot be set, a new dialogue
box will prompt you to re-enter the
code.
6 If you want to change the code, select
[Features] > [Change code].
7 Enter your current code using the
Numeric buttons.
If the code is validated, a new dialogue »
box will prompt you to enter your
new code.
8 Enter the new code using the Numeric
buttons.
A message appears prompting you »
to enter the new code again for
confirmation.
Tip
If you forget your code, enter ‘8888’ to •
override any existing codes.
3 Press to set the sleep time.
The sleeptimer can be up to 180 »
minutes in steps of five minutes. If
set to zero minutes, the sleeptimer is
switched off.
4 Press OK to activate the sleeptimer.
The TV switches to standby after the »
pre-defined period of time.
Automatically switch the TV on (on
timer)
You can switch the TV to a specified channel
at a specified time, from standby.
1 Press MENU.
2 Select [Features] > [On timer] .
3 Press to enter the [On timer] menu.
4 Press to select [Activate] and set a
frequency - [Daily], [Once] or [Off].
5 Press OK to confirm.
6 Press to select [Time] and set the
starting time.
7 Press [Done] to confirm.
8 Press to select [Programme no.]
and set the channel.
9 Press OK to confirm.
10 Press MENU to exit.
Tip
Select • [On timer] > [Activate] > [Off] to
disable [On timer].
When
• [On timer] is [Off], only [Activate] can
be selected.
Set the TV clock before activating
• [On
timer]feature (see ‘Set the TV clock’ on page
16).
English
EN
Downloaded From TV-Manual.com Manuals
To Next Page
Loading...
