CABLE
BOX CONNECTIONS
2
I
f you cable signal uses a cable box or
decoder, follow the easy steps below to
omplete the connection.
Cable Box (w/RF In/Outputs):
his connection will be mono.
1
Connect the Cable Company
supplied cable to
the signal IN(put)
plug on the back of the Cable Box.
2
Using a separate round coaxial cable,
connect one end to the
OUT(put)
(TO TV) plug on the back of the
Cable Box.
3
Connect the other end of the
round coaxial cable to the 75Ω
input on the back of the television.
Screw it down finger tight.
NOTE: If applicable, set the OUTPUT
HANNEL SWITCH on the back of the
able box to CH 3 or 4. Tune the TV to
he same channel and change channels at
he cable box. In some cases, the cable box
ill automatically tune to either channel 3
r 4, change channels until the picture
ppears.
Cable Box (w/Audio/Video Outputs):
his connection will supply Stereo sound.
4
Connect the Cable Company
supplied cable to
the cable signal
IN(put) plug on the back of the
Cable Box.
5
Using a RCA type Video Cable, con-
nect one end of the cable to the
Video (or ANT, your cable box may be
labeled differently) Out jack on the
cable box and the other end to the
AV1 Video Input on the TV.
6
Connect one end of the Audio Left
and Right Cable to the left and
right Audio Out L & R jacks on
the cable box. Connect the other
end to the AV In Audio L & R Input
jacks on the TV.
NOTE: Use the AV button on the TV
emote control to tune to the AV channel
or the cable box signal. Once tuned,
hange channels at the cable box, not the
elevision.
To Next Page
Loading...
