8
While keeping the release button pressed, tilt 3.
the base and slide it out.
Note
This monitor accepts a 100mm x 100mm VESA-
Compliant mounting interface.
Place the monitor face down on a smooth 2.
surface, taking care to avoid scratching or
damaging the screen. Then lift the monitor
stand.
100mm
100mm
2.3 Remove the Base
Condition:
For VESA standard mounting applications•
Before you start disassembling the monitor base,
please follow the instructions below to avoid
damage or injury.
Extend the monitor base to its maximum 1.
height.
220P2
To Next Page
Loading...
