Philips 22PFT54 3 Series - Adjusting VGA Settings; Playing Multimedia Files from USB Devices

12 EN
Playing multimedia les from
USB devices
You can play photo, music or video les stored
on a USB storage device on your TV.
• Supported storage devices: USB (only
FAT or FAT 32 USB storage devices are
supported)
• Supported multimedia le formats:
• Images: JPEG
• Audio: MP3
• Video: MPEG 2/MPEG 4, H.264
• Documents: TXT
Note
•
TP Vision assumes no responsibility if a USB storage
device is not supported, or if the data on the device is
damaged or lost.
Viewing photos and text les and
playing audio and video les
1 Turn the TV on.
2 Connect the USB storage device to the
USB port on the side of the TV.
3 Press (SOURCES).
4 Select [USB] and press OK.
» The USB browser will open.
Viewing photos
1 Select the photo within the USB browser
and press OK. The photo will be enlarged
to ll the screen.
• Press CH- or CH+ to see either the
previous or the next photo.
Starting slide shows
1 Select a photo or folder and then press
OK. The photo will be enlarged to ll the
screen.
» The slide show will start playing from
the selected photo.
4 Repeat this step to adjust the channel ratings.
• [Parental Rating]: when channels are
locked:
• Enter the four-digit password to
access the channel blocking menu.
• Enter the four-digit password to view
locked channels.
• Enter the four-digit password to
access the parental lock menu.
• [Clear All]: this function will clear all
previously saved locked channels and signal
sources.
• The default password is ‘0000’. Users
may change or set the password
themselves.
Note
•
If you go to a locked channel, you will be prompted to
enter the password.
Adjusting VGA settings
1 Press Press (Home) and select [Setup] to
enter the [Setup] menu.Then select [VGA
Setting].
» The [VGA Setting] menu is displayed.
2 Press to select and adjust the settings:
• [Auto Adjust]: automatically adjusts the TV
to synchronise its resolution with that of
the PC, so that programmes are displayed
in full screen.
• [H.Position]: adjusts the horizontal
position.
• [V.Position]: adjusts the vertical position.
• [Phase]: adjusts the phase frequency of the
VGA signal.
• [Clock]: adjusts the clock frequency of the
VGA signal.
Tip
•
The [VGA Setting] menu can only be used when
connected to a PC.