Philips 272E1 - Remove the Base Assembly for VESA Mounting

13
2. Setting up the monitor
275E1E
Tilt
20
-5
Height adjustment
100mm
Warning
• To avoid potential screen damage,
such as panel peeling, ensure that
the monitor does not tilt downward
by more than -5 degrees.
• Do not press the screen while
adjusting the angle of the monitor.
Grasp only the bezel
2.3 Remove the Base Assembly
for VESA Mounting
Before you start disassembling the
monitor base, please follow the
instructions below to avoid any possible
damage or injury.
27xE1S
1. Place the display face down on a
smooth surface. Pay attention not to
scratch or damage the screen.
2. (1) Use screwdriver to loosen the
screw located at the bottom of
the base.
(2) Use your fingers to loosen the
screw located at the bottom of
the base,and remove the base
from the stand.
2
1
3
3. Remove the hinge cover from
monitor body by using your fingers.