Philips 272E1GAJ - Page 12

10
2. Setting up the monitor
4. Use a screwdriver to remove the
screws on the arm, and then detach
the arm/stand from the monitor.
Note
This monitor accepts a 100mm x 100mm
VESA-Compliant mounting interface.
VESA Mounting Screw M4. Always
contact manufacturer for wall-mount
installation.
100mm
100mm
272E1GAJ
1. Place the monitor face down on a
smooth surface. Pay attention not to
scratch or damage the screen.
2. Use a screwdriver to loosen the
screw located at the bottom of the
base, and remove the base from the
stand.
1
3
2
3. Remove the hinge cover from
monitor body by using your fingers.