Philips 27G7 - Page 29

Options Sub-menu
Allows the servicer to change the chassis feature bits listed in the Options List. This sub-menu also allows the
servicer to change the feature bytes of the set; these are OB1, OB2, OB3, OB4, OB5, OB6, and OB7. The
feature byte values will also change when the feature bits are changed.
When accessing feature bits, refer to the Options List to determine what particular feature is controlled by each
bit.
When accessing feature bytes, refer to the Feature Byte Values table to see the factory preset feature word.
This allows the servicer to set the feature package of the unit.
1. Enter the Service Alignment Mode (SAM) by pressing the following key sequence on the remote control
transmitter:
0-6-2-5-9-6-Status
Do not allow the display to time out between entries while keying the sequence.
2. From the top level SAM menu, use the Menu Up/Down keys to highlight the OPTIONS sub-menu.
3. To enter the OPTIONS sub-menu, press the Menu Left or Menu Right key.
4. To select an option code or option byte, use the Menu Up or Menu Down keys on the remote control.
5. Use the Menu Up/Down keys to highlight a feature bit, then use the Menu Left/Right keys to toggle the
feature bit ON or OFF. (Remember that when feature BIT values are changed, the feature BYTE values
will automatically change.)
6. To change a feature byte, use a 3 digit entry on the remote control. (Remember that when feature BYTE
values are changed, the feature BIT values will automatically change.)
Note: Option byte values must be entered in three-digit form.
Example 1: ”87“ would be entered as ”0-8-7“
Example 2: ”4“ would be entered as ”0-0-4“
7. Any changes made to either the feature bits or feature bytes must be stored to take effect. To store the
values:
a. Use the Menu Up/Down keys to highlight STORE.
b. Press the Menu Right key to store the new option settings. The STORE text will briefly
change to STORED.
c. When the text changes back to STORE, press the Menu button to return to the top level SAM
menu. The changes are now stored in NVM.
d. To return to the top level SAM menu without storing changes, simply press the Menu button
without performing the STORE procedure.
8. If no changes to the feature bits or feature bytes are required, press Menu to exit the OPTIONS sub-menu
and return to the top level SAM menu.