Caution: Do not turn the grinder adjustment knob more than one notch at a time to prevent
damage to the grinder.
Note: The difference becomes noticeable after you have brewed 2-3 cups of coffee at the
new setting.
Handling the brew group
Go to www.philips.com/coffee-care for detailed video instructions on how to remove, insert
and clean the brew group.
Removing the brew group from the machine
1 Turn off the machine by pressing the main turn on the back of the machine.
2 Remove the drip tray with the coffee grounds container.
3 Open the service door (Fig. 20).
4 Press the PUSH button (Fig. 21) and pull at the grip of the brew group to remove it from the
machine (Fig. 22).
5 Remove the coffee residues drawer (Fig. 23).
Reinserting the brew group
Before you slide the brew group back into the machine, make sure it is in the correct position.
1 Check if the arrow on the yellow cylinder on the side of the brew group is aligned with the
black arrow and N (Fig. 24).
-
If they are not aligned, push down the lever until it is in contact with the base of the
brew group (Fig. 25).
2 Make sure that the yellow locking hook on the other side of the brew group is in the correct
position.
-
To position the hook correctly, push it upwards until it is in uppermost position (Fig. 26).
3 Place back the coffee residues drawer.
4 Slide the brew group back into the machine along the guiding rails on the sides until it
locks into position with a click. Do not press the PUSH button.
5 Place back the drip tray with the coffee grounds container.
Cleaning and maintenance
Regular cleaning and maintenance keeps your machine in top condition and ensures good-
tasting coffee for a long time, a steady coffee flow and a perfect milk froth.
Consult the table on when and how to clean all detachable parts of the machine. You can find
more detailed information and video instructions on www.philips.com/coffee-care.
19
English
To Next Page
Loading...
