4-2 PL14.32-A_DC
Important precautions concerning the
LCD Panel Assembly:
1. When you disassemble/re-assemble the Front
Cabinet
• Do not pull the FFC Cable and Board Cable
forcefully when you re-assemble.
• Be careful not to scratch the display panel when
assembling.
• Be careful not to break the hooks. If you pull with too
much force, the hooks may be damaged.
• Make sure the hooks are securely in place when
assembling.
2. When you disassemble/re-assemble the
Function CBA Unit or the IR Sensor CBA Unit
• Be careful not to break the hooks. If you pull with too
much force, the hooks may be damaged.
• Make sure the hooks are securely in place when
assembling.
• The Function CBA Unit, Function Knob and Knob
Frame are fixed in place by the hooks. Make sure
these hooks are not damaged. Make sure the
Function CBA Unit, Function Knob and Knob Frame
are securely in place when re-assembling.
• The IR Sensor CBA Unit and Sensor Shield are
fixed in place by the hooks. Make sure these hooks
are not damaged. Make sure the IR Sensor CBA
Unit and Sensor Shield are securely in place when
re-assembling.
[1] Stand Assembly
(S-2)
(S-2)
(S-2)
(S-2)
(S-3)
(S-3)
[2] Rear Cabinet
(S-1)
Fig. D1
To Next Page
Loading...
