Philips 40PFL4707/F7 - Page 13

English
13
Note
• Ifyouarenotreceivingasignalfromyourcableservice,contacttheCableprovider.
• Ifyoupress orMENU/EXITduringautoprogram,thissetupofTVchannelswillbe
canceled.
• TheinitialautoprogramfunctioncanbeexecutedforeitherAntennaorCableonly
once.Whenyouchangetheconnection(Antenna/Cable),setAutoprogramagain.
➠
p.20
• IfthereisnosignalInputfromtheantennaterminalandnooperationforseveral
secondsafteryouTurnOntheunit,helpfulhintsappears.Followtheinstructionslisted
ontheTVscreen.
Initialsetup
Nochannelisregistered.
TryAutoprogramagain?
Verifythatyouhaveacableconnectedtothe“ANTENNAIN”jack
onthebackoftheTV,thechannelinstallationprocess
searchesthisconnection.Ifyouareusingacableorsatellite
box,pleaseconfirmtheinputwhichyouhaveconnectedto
theboxandpress“SOURCE”keyontheremotecontrolto
selecttheappropriatesourceinput.

Retry
Later
Select OK Skip
After an initial setup is completed...
• Ifyouwanttoscanthechannelsautomaticallyagain.
  Autoprogram 
➠
p.20
• YoucanaddthedesiredcableandAnalogchannels
unmemorizedbyautoprogram.
  Addchannels 
➠
p.21
• Ifyouwanttochangetoanotherlanguage.
  Language 
➠
p.27
• Ifyouwanttochangethelocationsetting.
  Location 
➠
p.27
• Ifyouwanttorestorethepicturesetting.
  Settingsassistant 
➠
p.19