Philips 40PFL4707/F7 - AttachingTheBase; ManagingCables; InstallingTheRemoteControlBatteries

English
8
Attachingthebase
Youmustattachthebasetotheunittohaveitasatabletopunit.
Besurethefrontandrearofthebasematchtheproperdirection.
ForlargescreenTVs,atleast2peoplearerequiredforthesesteps.
1
4
5
2
4 5
x
4
Note
• Makesuretouseatablewhichcansupporttheweightofthisunitandislargerthan
thisunit.
• Makesurethetableisinastablelocation.
• Whenattachingthebase,ensurethat“FRONT”with“arrow”writtenonthebottomof
thebaseisdownward.
• Whenattachingthebase,ensurethatallscrewsaretightlyfastened.Ifthebaseisnot
properlyattached,itcouldcausetheunittofall,resultingininjuriesaswellasdamage
totheunit.
• Toremovethebasefromthisunit,unscrewthePhillipsheadscrewsinstep2.
Becarefulnottodropthebasewhenyouremoveit.
Managingcables
Routeyourantennacableandallothercablesthroughthecable
managementtieatthebackoftheTV.
Theholderhelpskeepyourcablestidyandeasilymanageable.
1 Attachthecablemanagementtieasillustratedbelow.
2 Passcablesthroughthecablemanagementtietoavoidtangles.
Installingtheremotecontrolbatteries
1 Slidethebatterycoveroffthebackoftheremotecontrol.
2 Insertthe2suppliedbatteries(AAA,1.5V).Besurethe+and−
endsofthebatterieslineupwiththemarkingsinsidethecase.
3 Slidethecoverbackintoposition.
Note
• Removethebatteriesifnotusingtheremotecontrolforanextendedperiodoftime.