Service Modes, Error Codes, and Fault Finding
EN 30 Q548.1E LB5.
2009-Dec-18
Figure 5-12 SSB replacement flowchart - set starting up in Factory Mode
H_16771_007b.eps
091119
Restart the set
Set is starting u p in F actory m od e
Set is starting up in Factory mode?
Noisy picture with bands/lines is visible and the
RED LED is continuous on.
An “F” is displayed and the HDMI 1
input is displayed.
- Press the “volume minus” button on the TVs local keyboard for 10
seconds
- Press the “SOURCE” button for 10 seconds until the “F” disappears
from the screen or the noise on the screen is replaced by “blue mute”
The noise on the screen is replaced
with the blu
e mute or the “F” is disappeared!
Unplug the mainscord to verify the correct
disabling of the factory-mode.
Program display option code
via “062598 MENU”, followed by
the 3 digits code of the display
(this code can be found
on a sticker inside the set).
After entering “display option” code, the set is
going in stand-by mode (= validation of code)
To Next Page
Loading...
