Philips 40PFT4100/12 - IR;LED Panel; Speakers; Small Signal Board (SSB); Speakers Removal

Mechanical Instructions
EN 18 TPN15.1E LA4.
2015-Oct-30
back to
div. table
4.3.2 IR/LED panel
1. Unplug the connector[4] from the IR/LED panel.
2. Gently release the clip hold and take it out from the bezel.
When defective, replace the whole unit. Refer to Figure 4-15
for details.
4.3.3 Speakers
Refer to Figure 4-16
for details.
1. Release the connector [5] from the SSB.
Caution: be careful, as these are very fragile connectors!
2. Remove fixation screws [6] that secure the speakers, refer
to Figure 4-16
for details.
3. Gently lift the speakers from the TV. Make sure that wires
and cables are not damaged while lifting the speakers from
the set.
When defective, replace the whole unit.
Figure 4-16 Speakers removal
4.3.4 Small Signal Board (SSB)
Refer to Figure 4-17
for details.
Caution: it is mandatory to remount all different screws at their
original position during re-assembly. Failure to do so may result
in damaging the SSB.
1. Release the clips from the LVDS [1] connector that connect
with the SSB.
Caution: be careful, as these are very fragile connectors!
2. Unplug all other connectors [2].
3. Remove all the fixation screws [3] from the SSB.
4. The SSB can now be shifted from side connector cover,
then lifted and taken out of the I/O bracket.Refer to
Figure 4-17
for details.
Figure 4-17 SSB removal
19790_103.eps
6
6
6
6
5
19790_104.eps
2
1
3
3
3
3