EN 42
[3 or 4 satellites (DiSEqC 1.0)]: Select
for 3 or 4 LNBs.
[Unicable for 1 satellite]: Select if you
have a Unicable setup with 1 satellite.
[Unicable for 2 satellites]: Select if you
have a Unicable setup with 2 satellite.
Manual installation
If a transponder is skipped during installation,
you can test the signal strength of a
transponder or add a new transponder.
1. While you watch TV, press .
2. Select [Setup] > [Search for satellite] >
[Manual installation], then press OK.
3. Select the LNB.
4. If you know the frequency of the
transponder (which can include several
channels), select [Frequency] and set the
frequency.
5. Select [Search], then press OK.
6. If a new frequency is found, press [Store]
to add the new transponder with its
channels.
Update satellite channels
1. While you watch TV, press .
2. Select [Setup] > [Search for satellite] >
[Update channels].
3. Follow the onscreen instructions to
complete the installation.
4. Once complete, select [Finish], and then
press OK.
Add and remove satellites
You can add or remove satellites at any time,
and install channels from new satellites.
Note: Before you add satellites, make sure
that the connection type is correct. See
Change your TV settings > Satellite Settings
> Install satellite channels (Page 41).
1. Press .
2. Select [Setup] > [Search for satellite],
then press OK.
3. Select [Add satellite], then press OK.
The TV searches for a satellite on the first
free LNB. This can take several minutes.
4. If no satellite is found, check the antenna
connections and the position of the dish
antenna, then select [Search again].
5. If you are satisfied with the added satellite,
select [Next] to install all channels from the
satellite.
The installation can take several minutes.
Remove a satellite
1. Press .
2. Select [Setup] > [Search for satellite] >
[Remove satellite], then press OK.
3. Select the satellites you want to remove,
then select [Remove] and press OK.
To Next Page
Loading...
