Philips 559M1 - Page 18

16
2. Setting up the display
4
MultiView in OSD menu
[PBP]: Picture by Picture
Open up a sub-window
side-by-side of another
signal source.
A (main) B
When the sub source is
not detected:
A (main) B
Note
The black strip shows on the top and
the bottom of the screen for the correct
aspect ratio when in the PBP mode. If
you expect to see full screen side by
side, adjust your devices resolution as
pop up attention resolution, and make
sure graphic card’s resolution is set to
‘1920 x 2160 at 60Hz’.
[PBP Input]: There are 5 different video
inputs to choose as the sub
display source: [1 HDMI 2.1],
[2 HDMI 2.1], [3 HDMI 2.1],
[DisplayPort], [USB C].
SUB SOURCE POSSIBILITY (xl)
Inputs
HDMI 1 HDMI 2 HDMI 3
DisplayPort
USB C
MAIN
SOURCE
(xl)
HDMI 1
● ● ● ● ●
HDMI 2
● ● ● ● ●
HDMI 3
● ● ● ● ●
DisplayPort
● ● ● ● ●
USB C
● ● ● ● ●
[Swap]: The main picture source and
the sub picture source swapped
on the display.
Swap A and B source in [PBP] mode:
A (main) B
↔
B (main) A
• Off: Stop MultiView function.
Note
When you do the SWAP function, the
video and its audio source will swap at
the same time.