Satellite CAMs
If you use a CAM – a Conditional Access Module with a
smart card – to watch satellite channels, we recommend
to do the satellite installation with the CAM inserted in
the TV.
Most CAMs are used to descramble channels.
CAMs (CI+ 1.3 with Operator Profile) can install all the
satellite channels by themselves on your TV. The CAM
will invite you to install its satellite(s) and channels. These
CAMs not only install and descramble the channels but
also handle regular channel updates.
Channel List Copy
Introduction
Channel list copy and Satellite list copy are intended for
dealers and expert users.
With Channel list copy/Satellite list copy you can copy
the channels installed on one TV onto another Philips TV
of the same range. You can avoid the time-consuming
channel search by uploading a predefined channel list on
a TV.
Conditions
• Both TVs are from the same year range.
• Both TVs have the same hardware type. Check the
hardware type on the TV type plate on the back of the
TV.
• Both TVs have compatible software versions.
• Use a USB flash drive of minimum 1 GB.
Copy a Channel List, Check Channel List Version
Copy a channel list to USB flash drive
To copy a channel list…
1 - Switch on the TV. This TV should have channels
installed.
2 - Plug in a USB flash drive to USB 2* port.
3 - Select (Home) > Settings > Channels > Channel list
copy or Satellite list Copy and press OK.
4 - Select Copy to USB and press OK.
5 - When copying is done, unplug the USB flash drive.
Now you can upload the copied channel list onto
another Philips TV.
* Note: only the USB port that marked with USB 2
supports copying channel list operation.
Check channel list version
(Home) > Settings > Channels > Channel list copy or
Satellite list Copy > Current version
Upload a Channel List
To not Installed TVs
Depending on whether your TV is already installed or
not, you must use a different method to upload a
channel list.
To a TV that is not yet installed
1 - Plug in the power plug to start the installation and
select language and country. You can skip the channel
search. Finish the installation.
2 - Plug in the USB flash drive that holds the channel list
of the other TV.
3 - To start the channel list upload, select
(Home) > Settings > Channels > Channel List Copy or
Satellite list Copy > Copy to TV and press OK. Enter your
PIN code if necessary.
4 - The TV notifies you if the channel list is copied to the
TV successfully. Unplug the USB flash drive.
To Installed TVs
Depending on whether your TV is already installed or
not, you must use a different method to upload a
channel list.
To an already installed TV
1 - Verify the country setting of the TV. (To verify this
setting, see chapter Re-install channels. Start this
procedure until you reach the country setting.
Press Back to cancel the installation.)
If the country is correct continue with step 2.
If the country is not correct, you need to start a
reinstallation. See chapter Re-install channels and start
the installation. Select the correct country and skip the
channels search. Finish the installation. When done,
continue with step 2.
2 - Plug in the USB flash drive that holds the channel list
of the other TV.
3 - To start the channel list upload, select
(Home) > Settings > Channels > Channel List Copy or
Satellite list Copy > Copy to TV and press OK. Enter your
PIN code if necessary.
4 - The TV notifies you if the channel list is copied to the
TV successfully. Unplug the USB flash drive.
Channel Options
Open Options
While watching a channel, you can set some options.
Depending on the type of channel you are watching or
depending on the TV settings you made, some options
are available.
To open the options menu…
1 - While watching a channel, press OPTIONS.
21
To Next Page
Loading...
Need help?
General
Weight and Dimensions
