1 - Press
, select All Settings and press OK.
2 - Select Region and Language and
select Clock > Auto Clock Mode.
3 - Select Automatic or Country Dependent.
4 - Press
(left) to go back one step.
Manual
If none of the automatic settings display the time
correctly, you can set the time manually.
However, if you schedule recordings from the TV
Guide, we recommend not to change the time and
date manually. In some countries, for some network
operators, the clock settings are hidden to avoid an
incorrect clock setting.
To set the TV clock manually (if available)…
1 - Press
, select All Settings and press OK.
2 - Select Region and Language and
select Clock > Auto Clock Mode and press OK.
3 - Select Manual and press OK.
4 - Press
(left) and select Date or Time.
5 - Press
(up) or
(down) to adjust the value.
6 - Press
(left) to go back one step.
Time Zone
For some countries, you can select specific time
zones to set the TV clock correctly.
To set the time zone (if available)…
1 - Press
, select All Settings and press OK.
2 - Select Region and Language and
press
(right) to enter the menu.
3 - Select Clock > Time Zone.
4 - According to your country, you can select a time
zone or set a time offset to correct the TV clock.
5 - Press
(left) repeatedly if necessary, to close
the menu.
Sleep Timer
With the Sleep Timer, you can set the TV to switch to
Standby automatically after a preset time.
To set the Sleep Timer…
1 - Press
, select All Settings and press OK.
2 - Select Region and Language and
press
(right) to enter the menu.
3 - Select Clock > Sleep Timer.
4 - With the slider bar you can set the time to up to
180 minutes in increments of 5 minutes. If set to 0
minutes, the Sleep Timer is switched off. You can
always switch off your TV earlier or reset the time
during the countdown.
5 - Press
(left) repeatedly if necessary, to close
the menu.
Remote Control Keyboard
To set the keyboard layout to Azerty…
1 - Press
, select All Settings and press OK.
2 - Select Region and Language and
press
(right) to enter the menu.
3 - Select Remote Control Keyboard.
4 - Select Azerty or Qwerty.
5 - Press
(left) repeatedly if necessary, to close
the menu.
12.8
Universal Access
Switch On
With Universal Access switched on, the TV is
prepared for use for the deaf, hard of hearing, blind or
partially sighted people.
Switch on
If you did not switch on Universal Access during the
installation, you can still switch it on in Universal
Access menu.
To switch on Accessibility…
1 - Press
, select All Settings and press OK.
2 - Select Universal Access and press
(right) to
enter the menu.
3 - Select Universal Access one step further.
4 - Select On.
5 - Press
(left) repeatedly if necessary, to close
the menu.
Hard of Hearing
Some digital TV channels broadcast special audio and
subtitles adapted for the hard of hearing or deaf
people. With Hearing impaired switched on, the TV
automatically switches to the adapted audio and
subtitles, if available. Before you can switch
on Hearing impaired, you have to switch
on Universal Access.
To switch on Hearing impaired…
1 - Press
, select All Settings and press OK.
2 - Select Universal Access and press
(right) to
enter the menu.
3 - Select Hearing impaired and press
(right) to
enter the menu.
4 - Select On.
5 - Press
(left) repeatedly if necessary, to close
the menu.
61
To Next Page
Loading...
