5. Indicates the type of TV system or whether or not the television is receiving an
"IDENT" signal on the selected source. If no "IDENT" signal is detected, the
display will read "NOT TUNED"
6. Error code buffer. Displays the last five errors detected in the error code buffer.
How to exit CSM
To exit CSM, use one of the following methods:
• Press the MENU, STATUS/EXIT, or POWER button on the remote control
transmitter.
• Press the POWER button on the television set.
Problems and Solving Tips Related to CSM
Picture Problems
Note: The problems described below are all related to the TV settings. The procedures
used to change the value (or status) of the different settings are described.
Picture too dark or too bright
If:
• The picture improves when you have press the AUTO PICTURE button on the
remote control transmitter, or
• The picture improves when you enter the Customer Service Mode
To Next Page
Loading...
