How To Read The Error Buffer
You can read the error buffer in 3 ways:
• On screen via the SDAM (if you have a picture). Examples:
§ ERROR: 0 00 0 0 : No errors detected
§ ERROR: 6 0 0 0 0 : Error code 6 is the last and only detected error
§ ERROR: 9 6 0 0 0 : Error code 6 was detected first and error code 9 is the
last detected (newest) error
• Via (when you have no picture). See "The Blinking LED Procedure"
• Via ComPair.
How To Clear The Error Buffer
• The error code buffer is cleared in the following cases:
• By using the CLEAR command in the SDAM menu:
§ To enter SDAM, press the following key sequence on the remote control
transmitter:
§ 0-6-2-5-9-6-MENU
§ Do not allow the display to time out between entries while keying the sequence.
§ Make sure the menu item CLEAR is highlighted. Use the MENU
UP/DOWN buttons, if necessary.
§ Press the MENU RIGHT button to clear the error buffer. The text on the
right side of the "CLEAR" line will change from “CLEAR?" to "CLEARED"
• If the contents of the error buffer have not changed for 50 hours, the error buffer
resets automatically.
Note:
If SDAM is exited by disconnecting the AC power from the television set, the error buffer
is not reset.
To Next Page
Loading...
