Philips AC2885/40 - Filter Reset; Storage

16 EN
Filter reset
You can replace filters even if there is
no filter replacement code displayed on
the screen. After replacing a filter, you
need to reset the filter lifetime counter
manually.
1 Touch and simultaneously
for 3 seconds to enter the filter reset
mode (fig.~).
» Code (A3) of the NanoProtect
True HEPA filter displays on the
screen.
2 Touch and hold for 3 seconds to
force reset the filter lifetime counter
of the NanoProtect True HEPA filter
(fig.}).
3 Code (C7) of the NanoProtect
Active Carbon filter displays on the
screen after the lifetime counter of
the NanoProtect True HEPA filter
has been reset (fig.).
4 Touch and hold for 3 seconds to
force reset the filter lifetime counter
of the NanoProtect Active Carbon
filter and exit the filter reset mode
(fig.€).
7 Storage
1 Turn off the air purifier and unplug
from the wall outlet.
2 Clean the air purifier, air quality
sensor and pre-filter (see chapter
‘Cleaning’).
3 Let all parts air dry thoroughly
before storing.
4 Wrap the filters and pre-filter
separately in air tight plastic bags.
5 Store the air purifier, filters and pre-
filter in a cool, dry location.
6 Always thoroughly wash hands
after handling filters.