Philips AC2887/10 - Getting Started: Filter Installation; Installing Air Filters

6 EN
4 Using the
appliance
Understanding the air
quality light
Air quality light
color
Air quality level
Blue
Good
Blue-violet
Fair
Red-purple
Unhealthy
Red
Very unhealthy
The air quality light automatically goes
on when the air purifier is switched on,
and lights up all colors in sequence.
After approximately 30 seconds, the
air quality sensors select the color that
corresponds to the surrounding air
quality of airborne particles.
Switching on and o
1 Put the plug of the appliance in the
wall outlet.
2 Touch to switch on the appliance
(fig.i).
» The appliance beeps.
» The appliance operates under
the general mode by default.
» After measuring the air quality
for a short time, the air quality
sensor automatically selects the
color of the air quality light.
» For AC2887, " " displays on
the screen when the appliance
is warming up. After measuring
the particle matters in the air,
the appliance goes to auto
mode with xx displayed on the
screen (fig. j).
3 Getting started
Installing lters
Note
• Make sure the air purifier is unplugged
from the electrical outlet before
installing the filters.
• Make sure the side of the filter with the
tag is pointing towards you.
1 Remove all packaging materials of
the air purification filters (fig.c).
2 Pull the bottom part of the front
panel to remove it from the
appliance (fig.d).
3 Press the two clips down and pull
the pre-filter towards you (fig.e).
4 Put the unpacked air purification
filters back into the appliance
(fig.f).
5 Attach the pre-filter back into the
appliance (fig.g).
Note
• Make sure that the side with the two
clips is pointing towards you, and that
all hooks of the pre-filter are properly
attached to the purifier.
6 Reattach the front panel by pressig
the top part of the panel onto the
top of the air purifier (1). Then,
gently push the panel against the
body of the air purifier (2) (fig.h).
7 Wash your hands thoroughly after
installing filters.