Remote control
Important!
• Before using the remote control, remove the insulation plastic tab as
shown in the figure.
• If the remote control does not function correctly or the operating
range is reduced, replace the battery with a new (CR2025) type
battery.
1.
Pull the battery tray out as shown in the figure.
2.
Replace a new battery according to polarity indication, and fully insert the
battery tray back to the original position.
Batteries contain chemical substances, so they should be disposed of
properly.
SELF-POWERED BACK-UP
The self-powered back-up conveniently allows your preset stations, alarm and clock
time settings to be stored for up to 10 minutes when there is a power interruption
e.g. AC power failure. The complete clock radio and backlight illumination will be
switched off.
If power supply returns after 10 minutes and the display shows:
• clock time blinking - indicates you need to re-adjust the clock time.
English
Congratulations on your purchase, and welcome to Philips! To fully
benefit from the support that Philips offers, register your product at
www.philips.com/welcome.
SUPPLIED ACCESSORIES
– 1 X certified AC/DC adapter: OH-1018A0902000U-SAA
(Input: 100-240V ~ 50/60Hz 650mA, Output: 9V 2A)
–
Docking kit
• 1 X Apple iPod dock (pre-installed with AJ301DB);
• dock adapters (4 adapters for different iPod types)
– 1 X AUX-IN cable
CONTROLS
(See 1)
1
POWER
– switches the system on or to standby mode
– stops active alarm for 24 hours
– deactivates the sleep function
2
¡1 / 2™
– adjust clock/alarm time
– selects previous/next tracks in the dock mode
– fast searches forward/backward in the dock mode
3
PRESET 1-5
– stores, recalls and shows radio station
4
SLEEP
– activates the sleep function
–
deactivates the sleep function
5
DOCK
– selects dock mode for Apple iPod
6
TUNER/ AUX
– selects FM radio mode
– selects AUX mode
7
2;
– starts/pauses playback in the dock mode
– selects 12 hour or 24 hour mode
2
3
1
CAUTION
High voltage! Do not open.You run the risk of getting an electric
shock. The machine does not contain any user-serviceable parts.
Modification of the product could result in hazardous radiation of
EMC or other unsafe operation.
To Next Page
