Philips AJ5300D/37 - Switch to Standby Mode; Set Time and Date

Turn on
Press .
» The clock radio switches to the last selected source.
Switch to standby mode
Press to switch the clock radio to standby mode.
» The clock (if set) is displayed.
Set time and date
1 In standby mode, press and hold TIME SET on the back of your
clock radio for more than two seconds.
» [12H] or [24H] begins to blink.
2 Press
/ repeatedly to select 12/24 hour format.
3 Press TIME SET to conrm.
» The hour digits begin to blink.
4 Repeat steps 2-3 to set hour and minute.
Note
• If clock is not manually set, when iPod/iPhone is connected, the unit
synchronizes time from the iPod/iPhone automatically.
Tip
• The accuracy of the transmitted time depends on the docked iPod/
iPhone that transmits the time signal.