AJT5300
Specications are subject to change without notice.
This product has been manufactured by, and is sold
under the responsibility of Gibson Innovations Ltd.,
and Gibson Innovations Ltd. is the warrantor in
relation to this product.
Philips and the Philips Shield Emblem are registered
trademarks of Koninklijke Philips N.V. and are used
under license.
AJT5300_79_QSG_V3.0
Register your product and get support at
Question?
Contact
Philips
Question?
Contact
Philips
www.philips.com/support
Always there to help you
BTFM
AUX
(Standby)
STANDBY
Quick Start Guide
www.philips.com/support
Always there to help you
Register your product and get support at
Question?
Contact
Philips
2 AA
Note:
• You can only use AC power as power supply.
The battery can only back up clock and alarm
settings.
Note: You can only set time in standby mode.
Quick start guide
SOURCE
FM
TUNE
SOURCE
TUNE
SOURCE
SCAN
SOURCE SOURCE
TUNE TUNE
Store radio stations manually
Select a preset radio station
Store radio stations automaticallyTune to FM radio stations
2 sec.
Philips AJT5300
SOURCE
After Bluetooth connection, you can control your incoming phone call with this product.
Button Function
Press to answer an incoming call.
During a call, press to end the current call.
Press and hold to reject an incoming call.
AL1 AL2
1 Fully extend and adjust the position of the pig-tail
antenna until you nd the best reception.
2 Fix the antenna as illustrated.
Note:
• If you cannot nd [Philips AJT5300] for pairing, press and hold for two seconds to enter
pairing mode, and then try again.
AJT5300_79_QSG_V3.0.indd 1 2017/6/29 10:13:19
To Next Page
Need help?
General
