Troubleshooting
My Philips Avent Baby monitor exceeds the
standard charging time
Is the parent unit of your Philips Avent Baby monitor taking more time to fully charge than the
indicated charging time? Find out what is causing this so you can try and solve this issue
yourself.
The parent unit is turned on
If the parent unit of your Philips Avent Baby monitor is turned on while charging, the charging
time will take longer than indicated. Turn off the parent unit during charging to reduce the
charging time.
Charging it for the first time
If you charge the parent unit for the first time, it will take longer to fully charge the parent unit of
your Philips Avent Baby monitor. This is also the case if you have not used your Philips Avent
Baby monitor for a while. After fully charging it for the first time it should meet the standard
charging time again.
Does the issue still persists? Please contact us for further assistance.
The information on this page applies to the following models: SCD730/86 , SCD720/86 ,
SCD630/37 , SCD501/10 , SCD560/10 , SCD570/10 , SCD603/10 , SCD600/10 , SCD535/00 ,
SCD525/00 , SCD510/00 , SCD530/00 , SCD520/00 , SCD589/54 , SCD590/54 .
My Philips Avent Baby monitor has a bad
connection
Use these possible causes and solutions if the parent unit of your Philips Avent Baby monitor
keeps losing connection or the sound gets interrupted.
Units are out of range
The baby unit and the parent unit of your Philips Avent Baby monitor might be out of operating
range. Obstructions, such as walls and trees, can limit the range of your Philips Avent Baby
To Next Page
Need help?
General
