Philips AW 7150 - Maintenance

Radio
RADIO RECEPTION
ysij6uq
Set the TAPE/RADIO selector to RADIO.
e Adjust the sound with VOLUME and TONE.
You may connect stereo headphones with
3.5 mm plug to the socket @ PHONES. The
loudspeakers will then be muted.
e Select the wave band using BAND selector.
Tune to a radio station using the TUNING
knob. (SW and LW not all versions).
For FM, pull out the telescopic aerial. To
improve FM reception, incline and turn the
aerial. Reduce its length if the FM signal is
too strong (usually occurs when very close
to a transmitter).
For MW/AM or LW, the set is provided with
a built-in aerial, so there is no need to use
the telescopic aerial. The aerial can be
directed by turning the whole set.
For short wave (SW), the telescopic aerial
must be pulled out and placed in the vertical
position. To improve SW-reception, vary the
lenght of the aerial.
The set is switched off if the TAPE/RADIO
selector is in position TAPE and no buttons
are pressed.
General
Recycling
MAINTENANCE
To ensure good recording and playback quality,
clean the parts (4) ® O © © indicated after
every 50 hours of operation or, on average,
once a month.
AW 7250
Deck 1
AW 7150
Deck 1 +2
AW 7250
Deck 2
e Open the cassette holder by pressing
EJECTA.
e Use a cottonball slightly moistened with
alcohol or a special head cleaning fluid.
e Press PLAY < and clean the rubber pressure
roller ©.
e Then press PAUSE U and clean the capstan
(8), and recording/playback head @) and
erase head €). After cleaning, press STOP E
Cleaning of the heads (A) and ©) can also be
done by playing a cleaning cassette through
once.
Remarks
Fingerprints, dust and dirt on the set can be
removed by using a soft, clean and slightly
damp leather cloth. Do not use any cleaning
agents, since they may damage the cabinet.
Do not expose the set, batteries and cassettes
to rain, moisture, sand, or to excessive heat
e.g. from heating equipment or in motor cars
parked in the sun.
RECYCLING
Please observe the local regulations regarding
the disposal of packing materials, exhausted
batteries and old equipment.
e All redundant packaging material has been
omitted. We have done our utmost to make
the packaging easy separable into three
mono-materials:
— cardboard (box),
— expandable polystyrene (buffer)
— polyethylene (bags, protective foam
sheet)
e Your set consists of materials which can be
recycled if disassembled by a specialized
company.
e Do not dispose of exhausted batteries with
your household waste.
ae ew tee