TROUBLESHOOTING
No sound /power
–
Volume not adjusted
• Adjust the VOLUME
–
Power cord not securely connected
• Connect the AC power cord properly
–
Batteries flat / incorrectly inserted
• Insert (fresh) batteries correctly
–
Headphones connected to the set
•Disconnect headphones
–
Electrostatic discharge/interference
•Unplug the set. If batteries inserted, remove batteries
from the battery compartment.. Press and hold
STANDBY ON y
for 10 seconds, then re-plug /
replace battery supply, and try activating the set again.
• When in USB PC LINK mode, check that your PC's
volume is audible and not set to minimum.
• When playing a CD from the PC's CD-ROM drive, refer
to USB PC Link - Enable digital CD audio output.
Severe radio hum or noise
–
Electrical interference: set too close to TV, VCR or
computer
• Increase the distance
Remote control does not function properly
–
Batteries flat/ incorrectly inserted
• Insert (fresh) batteries correctly
–
Distance/ angle between the set too large
•Reduce the distance/ angle
Poor radio reception
–
Weak radio signal
•FM: Adjust the FM telescopic antenna
indication
–
No CD inserted
•
Insert a suitable disc
–
CD badly scratched or dirty
• Replace/ clean CD, see Maintenance
–
Laser lens steamed up
•Wait until lens has cleared
The CD skips tracks
–
CD damaged or dirty
• Replace or clean CD
–
SHUFFLE or PROG is active
• Switch off SHUFFLE / PROG
is displayed in USB PC LINK
mode for more than 10 sconds
• Check the connection between your PC and the set. If
necessary, please refer to the chapter Connecting to
USB PC Link for the initial setup required.
• Make sure the connected PC is turned on and the
MusicMatch software is working.
If a fault occurs, first check the points listed below before taking the set for repair. If you are
unable to remedy a problem by following these hints, consult your dealer or service center.
WARNING: Do not open the set as there is a risk of electric shock! Under no
circumstances should you try to repair the set yourself, as this will
invalidate the warranty.