8
English
Radio reception
1 Adjust the source selector to MW or FM
to select your desired waveband.
2 Turn TUNING to tune to a radio station.
To improve reception
– For FM,pull out the telescopic aerial.Incline
and turn the aerial.Reduce its length if the
signal is too strong (very close to a
transmitter).
– For MW the set is provided with a built-in
aerial so the telescopic aerial is not needed.
Direct the aerial by turning the whole set.
3 To switch off the radio,adjust the source
selector to TAPE/
OFF position and check
the cassette keys are released.
CD Player
Display indication for CD functions:
– --:flashes when CD source just selected
– In stop mode:total track number
– During CD playback:2 and current
track number
REPEAT/ REPEAT ALL:when the
respective repeat mode is activated
– PROGRAM:when CD programme
active
– -- and PROGRAM:flashes when
programme memory full
– Er:no disc/ error in CD operation or
with the CD/ CD-(R) is blank or the disc
is not finalised (see Troubleshooting)
Playing a CD
1 Adjust the source selector to CD.
2 To open the CD door,lift the CD door at
the edge marked LIFT TO OPEN.
3 Insert a CD or CD-(R) with the printed
side facing up and press the CD door gently
close.
4 Press PLAY•PAUSE 2; on the set to
start playback.
5 To pause playback press PLAY•PAUSE
2;.To resume, press PLAY•PAUSE 2;
again.
➜ 2 flashes during pause
6 To stop CD play,press STOP 9.
7 To switch off the set,adjust the source
selector to TAPE/
OFF
position and check
the cassette keys are released.
Note:CD play will also stop when:
– you open the CD compartment;
– you select MW,FM or TAPE sound
source;
– the CD has reached to the end.
Radio CD-Player
.