English
DIGITAL TUNER GENERAL INFORMATION
7
To improve radio reception:
• For FM, pull out the telescopic aerial.
Incline and turn the aerial. Reduce its length if the signal is too
strong (very close to a transmitter).
• For MW (AM or LW), the set is provided with a built-in aerial
so the telescopic aerial is not needed. Direct the aerial by
turning the whole set.
Programming tuner stations
You can store up to a total of 30 tuner stations in the memory.
1. Tune to your desired station (see Tuning to radio stations).
2. Press PROG to activate programming.
™ Display:
PROG flashes.
3. Press PRESET 3 or 4 once or more to allocate a number from
1 to 30 to this station.
4. Press PROG again to confirm the setting.
™ Display:
PROG disappears, the preset number and the frequency
of the preset station are shown.
5. Repeat the above four steps to store other stations.
• You can overwrite a preset station by storing another frequency
in its place.
Tuning to preset stations
Press TUNER PRESET 4 or 3 until the desired preset station is
displayed.
General maintenance
• Do not expose the set, batteries, CDs or cassettes to humidity,
rain, sand or excessive heat caused by heating equipment or
direct sunlight.
• To clean the set, use a soft, slightly dampened chamois leather.
Do not use any cleaning agents containing alcohol, ammonia,
benzene or abrasives as these may harm the housing.
Safety information
• Place the set on a hard and flat surface so that the system
does not tilt. Make sure there is adequate ventilation to
prevent the system from overheating.
• The mechanical parts of the set contain self-lubricating
bearings and must not be oiled or lubricated.
AZ 1570/00
page 7
A
Z
1
5
6
0
C
D
R
A
D
I
O
C
A
S
S
E
T
T
E
R
E
C
O
R
D
E
R
O
S
T
O
P
P
L
A
Y
•
P
A
U
S
E
T
U
N
E
R
P
R
E
S
E
T
P
R
O
G
S
H
U
F
F
L
E
R
E
P
E
A
T
S
E
A
R
C
H
B
A
N
D
SOUND CONTROL CENTER
F
M
A
M
B
A
T
L
O
W
L
W
P
R
O
G
S
H
U
F
F
L
E
•
•
V
O
L
AZ15700A 15-12-2000 18:14 Pagina 7
To Next Page
Loading...
