Short User Manual
Specications are subject to change without notice.
2015 © Gibson Innovations Limited. All rights reserved.
This product has been manufactured by, and is sold
under the responsibility of Gibson Innovations Ltd., and
Gibson Innovations Ltd. is the warrantor in relation to
this product.
Philips and the Philips Shield Emblem are registered
trademarks of Koninklijke Philips N.V. and are used
under license from Koninklijke Philips N.V.
BT6000_94_SUM_V2.0
Short user manual
www.philips.com/support
Always there to help you
Register your product and get support at
Question?
Contact
Philips
OFF
ON
To turn the speaker on or off, rotate the knob clockwise
or anticlockwise until you hear a click.
Note:
• The speaker switches to standby mode after 15
minutes of inactivity.
• If the LED indicator is solid red, and the speaker
has no response when pressing any key, it means
the speaker is in DEMO mode. Press and hold
PAIRING for 15 seconds to exit this mode.
LED indicator Battery status
Solid red Under charging
Off Fully charged
Note:
• The speaker can operate on either built-in battery or AC power.
• The red LED indicator ashes when the battery level is low.
BT6000
1 Important
Warning
• Never remove the casing of this speaker.
• Never place this speaker on other electrical equipment.
• Keep this speaker away from direct sunlight, naked ames or heat.
• Make sure that you always have easy access to the power cord, plug, or
adaptor to disconnect the speaker from the power.
• Make sure that there is enough free space around the
speaker for ventilation.
• After use under humid circumstance, immediately clean the
product with a soft dry cloth.
• The battery shall not be exposed to excessive heat such as
sunshine, re or the like.
• The adapter shall not be exposed to dripping or splashing.
• No objects lled with liquids shall be placed on the adapter.
• Use only power supplies listed in the user manual.
• Where the plug of the Direct Plug-in Adapter is used as the
disconnect device, the disconnect device shall remain readily
operable.
Note
• The type plate is located on the bottom of the apparatus.
Notice
Any changes or modications made to this device that are not
expressly approved by Gibson Innovations may void the user’s
authority to operate the equipment.
This product is designed to be waterproof in compliance with IEC
60529 IPX4.
Care of the environment
Disposal of your old product
Your product is designed and manufactured with high
quality materials and components, which can be recycled
and reused.
Do not throw away the product with the normal household waste
at the end of its life, but hand it in at an ofcial collection point or
recycling. By doing this, you help to preserve the environment.
Caution
• Removal of the built-in battery
invalidates the warranty and may
destroy the product.
Always bring your product to a
professional to remove the built-in
battery.
Environmental information
All unnecessary packaging has been omitted. We have tried to
make the packaging easy to separate into three materials: cardboard
(box), polystyrene foam (buffer) and polyethylene (bags, protective
foam sheet.)
Your system consists of materials which can be recycled and reused
if disassembled by a specialized company. Please observe the local
regulations regarding the disposal of packaging materials, exhausted
batteries and old equipment.
Trademark notice
The Bluetooth® word mark and logos are
registered trademarks owned by Bluetooth
SIG, Inc. and any use of such marks by
Gibson Innovations Limited is under license. Other trademarks and
trade names are those of their respective owners.
The ‘N’ Mark is a trademark or registered
trademark of NFC Forum, Inc. in the
United States and in other countries.
This is CLASS II apparatus with double insulation, and no
protective earth provided.
Question?
Contact
Philips
Question?
Contact
Philips
Always there to help you
Register your product and get support at
www.philips.com/support
BT6000_94_SUM_V2.0.indd 1 13/10/2015 4:08:44 PM
To Next Page
Need help?
General
Weight and Dimensions
