Philips CD 910 - Page 8

PROGRAMMING
ysij6uq
STORING A PROGRAMME
(PROGRAMME and 1-0)
You can store 30 tracks from each CD in any
required sequence in a programme.
® In STOP mode, press P(rogramme) to open the
memory.
— ProG lights up and PROGRAM starts flashing.
© Key in the required numbers; every number you
key in will be directly included in the programme.
— Each time you key in (= store) a track number,
the number of tracks and the playing time of
your programme will be shown under TRACK
and TOTAL TIME.
— The track number indicator always shows
which numbers have been stored.
® Press P(rogramme), STOP/CP or PLAY/REPLAY
to quit the PROGRAMME mode.
FULL lights up if you exceed the maximum of 30
tracks.
CHECKING THE PROGRAMME (REVIEW)
e Press REVIEW prior to, during or after pro-
grammed play.
— All the numbers appear in the programmed
sequence under TRACK.
~ Under TRACK TIME you will see the playing
time of each track.
Errlights up if no track numbers have yet been
stored.
PLAYING THE PROGRAMME (PLAY/REPLAY)
e Press PLAY/REPLAY.
— Playback starts with the first number of the
programme.
All keys (except, P(rogramme), C(ancel) and EDIT)
can be used during programmed play.
Search for a particular passage is only possible
within the track being played.
ERASING A PROGRAMME
(STOP/CP or OPEN/CLOSE)
e Press STOP/CP twice or, if the CD has already
stopped, just once; you can also press
OPEN/CLOSE straight away.
— The programme has now been erased.
ERASING A TRACK FROM THE PROGRAMME
(CANCEL)
e Press REVIEW before or after programmed
play (STOP mode).
— All the numbers appear in the programmed
sequence under TRACK.
* Press C(ancel) as soon as the number you wish
to erase, appears.
— The number disappears from the number
indicator; It has now been erased.
— The display shows the remaining programme
time for a few seconds.