Philips CD 910 - Installation

INSTALLATION
pibirAL ONE:
H
}
| i
H
}
i
;
eit
{
UNPACKING
With this player are supplied:
— aconnection cable;
— a remote control (CD 920 only),
—
batteries
for
the
remote
control
(CD
920
only).
e
Remove
all
packaging
materials
from
the
player
and
the
accessories.
POWER SUPPLY SETTING
e Check that the type plate on the rear of your
player indicates the correct supply voltage.
e If yourmains supply voltage is different, consult
your dealer or our Service Organisation.
Certain versions of this player are equipped
with a voltage selector (5) which enables you
to
set
the
player
to
the
correct
mains
voltage
yourself. When changing the voltage setting, It
is also necessary to change the mains fuse (6)
to one of the correct rating:
T200 mA (slow blow fuse) for 110/127 V;
T100 mA (slow blow fuse) for 220 V - 230°V/
230 V -240 V.
English
FITTING A MAINS PLUG (U.K. only)
This apparatus is fitted with an approved moulded
13 Amp plug. To change a fuse in this type of plug
proceed as follows:
e Remove fuse cover and fuse.
e Fix new fuse which should be a BS1362 5A,
A.S.T.A. or BSI approved type.
@ Refit the fuse cover.
lf the fitted plug is not suitable for your socket out
lets, it should be cut off and an appropriate plug
fitted in its place. If the mains plug contains 4 fuse,
this should have a value of 5A. If a plug without a
fuse is used, the fuse at the distribution board
should not be greater than 5A.
NOTE
The severed plug must be disposed to avod a
possible shock hazard should it be inserted :
into.a 13A socket elsewhere.
HOW TO CONNECT A PLUG
The wires in the mains lead are coloured in eccor
dance with the following code:
BLUE - 'NEUTRAL' ('N')//BROWN - ‘LIVE’ (‘L")
e The BLUE wire must be connected to theter-
minal which is marked with the letter 'N' or
coloured BLACK.
e The BROWN wire must be connected to he
terminal which is marked with the letter '[’ or
coloured RED.
e Do not connect either wires to the earth te rm+
nal in the plug which is marked by the leter ‘E'
or by the safety earth symbol or colouredgreen
or green-and-yellow.
Before replacing the plug cover, make certam that
the cord grip is clamped over the sheath of ne
lead — not simply over the two wires.