EN
42
Connect a VCR or DVD recorder
With a eurocable
1. Connect the aerial cables 1 and 2 as
shown.
2. Connect the eurocable 3 as shown.
3. Make your selection of the source to which
the VCR has been connected in the Installation
menu, Select your connections, p. 29.
With the aerial cable only
1. Connect the aerial cables 1 and 2 as
shown.
2. Tune in your recorder’s testsignal and store the
testsignal under programme number 0.
See Analogue: manual installation, p. 26.
See also the handbook of your recorder.
Connect a decoder and a VCR
Connect a eurocable 4 to your decoder and
to the special euroconnector of your recorder.
See also the handbook of your recorder.
Warning: do not place your recorder too close to the screen as some recorders may be susceptible
for signals from the display. Keep a minimum distance of 0,5 m from the screen.
Tip: you can also connect your decoder
directly to EXT1 or EXT2 with a eurocable.
To Next Page
Loading...
