Philips CSS5530B - USB Playback and Software Updates

15EN
5 Update software
To get the best features and support, update
your product with the latest software.
Check software version
In HDMI ARC source, on the remote control
press TREBLE -, BASS -, and Volume - in
sequence within three seconds.
» The software version number is displayed
on the display panel.
Update software via USB
Caution
•
Do not turn off the power or remove the USB ash
drive when the software update is in progress because
you might damage this product.
1 Check the latest software version on
www.philips.com/support.
• Search for your model and click on
"Software and drivers".
2 Download the software into a USB ash
drive.
a Unzip the download if zipped, and
makesurethattheunzippedle
containstwoles:"CSS5530.bin"and
"RPT5530.bin".
b Putthetwoles("CSS5530.bin"and
"RPT5530.bin")intherootdirectory
oftheUSBashdrive.
3 Connect the USB ash drive to the USB
connector on this product.
4 Switch this product to HDMI ARC source
(press HDMI ARC).
5 On the remote control, within 6 seconds
press
twice then Volume + once, and
then hold down SOUND.
» Then “UPG” (upgrade) blinks on the
display panel.
» If a USB ash drive is not connected or
invalid upgrade le is found, “ERROR”
(error) is displayed on the display
panel.
6 Press on the remote control to start
the upgrade.
7 Wait until the upgrade is completed.
» If the upgrade is complete, this product
automatically turns off and on again.
Note
•
The upgrade time may take around 3 minutes.