Philips D2751W/12 - Important Safety Instructions; Power Requirements and Warnings; Damage Prevention and Operation; Operating and Storage Temperatures

EN 4
Power requirements
• This product requires an electrical supply
of 100-240 volts AC. In case of power
failure, the communication can be lost.
• The voltage on the network is classied
as TNV-3 (Telecommunication Network
Voltages), as dened in the standard EN
60950.
Warning
• The Electrical network is classied as
hazardous. The only way to power down
the charger is to unplug the power
supply from the electrical outlet. Ensure
that the electrical outlet is always easily
accessible.
• SAR value <0.1 W/kg
To avoid damage or malfunction
• Refer to safety information before using
the product.
• Use only the power supply listed in the
user instructions.
• Use only the batteries listed in the user
instructions.
• Risk of explosion if battery is replaced by
an incorrect type.
• Dispose of used batteries according to
the instructions.
• Do not dispose of batteries in re.
• Always use the cables provided with the
product.
• Do not allow the charging contacts or
the battery to come into contact with
metal objects.
• Do not let small metal objects come
into contact with the product. This can
deteriorate audio quality and damage
the product.
• Metallic objects may be retained if
placed near or on the handset receiver.
• Do not use the product in places where
there are explosive hazards.
• Do not open the handset, base station
or charger as you could be exposed to
high voltages.
• For pluggable equipment, the socket
outlet shall be installed near the
equipment and shall be easily accessible.
• Hands-free activation could suddenly
increase the volume in the earpiece to a
very high level: make sure the handset is
not too close to your ear.
• This equipment is not designed to make
emergency calls when the power fails.
An alternative has to be made available
to allow emergency calls.
• Do not allow the product to come into
contact with liquids.
• Do not use any cleaning agents
containing alcohol, ammonia, benzene,
or abrasives as these may harm the set.
• Do not expose the phone to excessive
heat caused by heating equipment or
direct sunlight.
• Do not drop your phone or allow objects
to fall on your phone.
• Active mobile phones in the vicinity may
cause interference.
About operating and storage temperatures
• Operate in a place where temperature is
always between 0°C to 40°C (up to 90%
relative humidity).
• Battery life may be shorter in low
temperature conditions.
1 Important safety
instructions