Philips D4502W/90 - Blacklist; Activate;deactivate the blacklist; Add blacklist numbers; Change the blacklist PIN;passcode

33EN
2 Enter the old barring PIN/passcode. The
default PIN is 0000. Then press [OK] to
conrm.
3 Enter the new PIN/passcode, then press
[OK] to conrm.
4 Enter the new PIN/passcode again, then
press [Save] to conrm.
» The setting is saved.
Blacklist
You can put numbers into the blacklist to block
incoming calls to certain undesirable numbers.
You can create 4 sets of numbers with 24 digits
at maximum for each set of numbers. When
there is an incoming call that starts with one
of these 4 sets of numbers, the ringer will be
muted.
Note
• Make sure you have subscribed to the caller ID service
before you use this feature.
• The contact's name in phonebook will not be displayed
if this contact's number matches the record saved in
the blacklist.
Activate/deactivate the blacklist
1 Select [Menu] > [Services] > [Blacklist],
then press [OK] to conrm.
2 Select [Blacklist mode], then press [OK]
to conrm.
3 Enter the PIN/passcode. The default PIN is
0000. Then press [OK] to conrm.
4 Select [On]/[Off], then press [OK] to
conrm.
» The setting is saved.
Add blacklist numbers
1 Select [Menu] > [Services] > [Blacklist],
then press [OK] to conrm.
2 Select [Blacklist], then press [OK] to
conrm.
3 Enter the PIN/passcode. The default PIN is
0000. Then press [OK] to conrm.
4 Enter the number, then press [OK] to
conrm.
» The setting is saved.
Change the blacklist PIN/passcode
1 Select [Menu] > [Services] > [Blacklist]>
[Change PIN], then press [OK] to conrm.
2 Enter the old barring PIN/passcode. The
default PIN is 0000. Then press [OK] to
conrm.
3 Enter the new PIN/passcode, then press
[OK] to conrm.
4 Enter the new PIN/passcode again, then
press [Save] to conrm.
» The setting is saved.
Network type
Note
• This is a country dependent feature. It only applies to
models with network type support.
1 Select [Menu] > [Services] > [Network
type], then press [OK].
2 Select a network type, then press [OK].
» The setting is saved.
Auto prex
This feature checks and formats your outgoing
call number before it is dialed out. The prex
number can replace the detect number you
set in the menu. For example, you set 604 as
the detect number and 1250 as the prex.
When you have dialed out a number such as