Philips D455 - Notice; Declaration of conformity; Use GAP standard compliance; Compliance with EMF

35EN
Register additional handsets
You can register additional handsets to the base
station. The base station can register up to 4
handsets.
Auto registration
Extra handsets of the same model can be auto-
registered. Place the unregistered handset on
the base station.
» The handset detects the base station
and registers automatically.
» Registration is complete in less
than two minutes. The base station
automatically assigns a handset number
to the handset.
Manual registration
If auto registration fails, register your handset
manually to the base station.
1 Select [Menu] > [Services] > [Register],
then press [OK] to conrm.
2 Press and hold on the base station for
5 seconds.
3 Enter the system PIN. Press [Clear] to
make corrections. Then press [OK] to
conrm the PIN.
» Registration is complete in less than 2
minutes. The base automatically assigns
a handset number to the handset.
Note
• If the PIN is incorrect or no base is found within a
certain period, your handset displays a notication
message. Repeat the above procedure if registration
fails.
• The preset PIN is 0000. No change can be made on it.
Unregister the handsets
1 Select [Menu] > [Services] > [Unregister],
then press [OK] to conrm.
2 Enter the system PIN. (The preset PIN
is 0000). Press [Clear] to remove the
number.
3 Select the handset number to be
unregistered.
4 Press [OK] to conrm.
» The handset is unregistered.
Tip
• The handset name is displayed beside the handset
number in standby mode.
Restore default settings
You can reset your phone settings to the
original factory settings.
1 Select [Menu] > [Services] > [Reset],
then press [OK] to conrm.
» A conrmation request is displayed on
the handset.
2 Press [OK] to conrm.
» All settings (except the phonebook
and direct access keys information) are
reset.