Philips D600 - ECO+ Mode; Name the Handset; Set the Display Language

28 EN
2 Select [On]/[Off], and press [OK] to
conrm.
» The setting is saved.
» is displayed in standby mode.
Note
• When ECO mode is set to [On], the connection
range between the handset and the base station can
be reduced.
ECO+ mode
When the ECO+ mode is activated, it
eliminates the transmission power of the
handset and base station in standby mode.
1 Select [Menu] > >[ECO+ mode], then
press [OK] to conrm.
2 Select [On]/[Off], and press [OK] to
conrm.
» The setting is saved.
Note
• Make sure that all the handsets registered to the base
station are D600/D605 in order to have the ECO+
feature functioning properly.
• When ECO+ is activated, the standby time is reduced.
This is because in ECO+ mode the base station is not
transmitting any signal in standby mode; therefore the
handset needs to “listen” more frequently for signals
from the base station to detect incoming calls or other
requests from the base station. The time it takes for the
handset to access features like call setup, call log, paging,
and phonebook browsing is also delayed. The handset
will not alert you to link loss in case of power loss or
moving out of range.
The following table shows you the current
status of the handset screen with different ECO
mode and ECO+ mode settings.
ECO
mode
ECO+
mode
Handset icon display
[Off] [Off]
and are off.
[Off] [On]
is displayed only after the
ECO+ mode is activated
during standby mode .
[On] [Off]
is displayed.
[On] [On]
is displayed and changed
to when the ECO+
mode is activated in
standby mode.
Name the handset
The name of the handset can be up to 16
characters. It is displayed on the handset screen
in standby mode.
1 Select [Menu] > > [Phone name], then
press [OK] to conrm.
2 Enter or edit the name. To erase a
character, select [Clear].
3 Press [Save] to conrm.
» The setting is saved.
Set the display language
Note
• This feature only applies to models with multiple-
language support.
• Languages available vary from country to country.
1 Select [Menu] > > [Language], then
press [OK] to conrm.
2 Select a language, then press [OK] to
conrm.
» The setting is saved.