Philips DC390 - 5 Listen to Radio; Tune to a Radio Station; Program Radio Stations Automatically; Program Radio Stations Manually

14
Program radio stations
automatically
You can program a maximum of 20 preset
radio stations.
1 In the tuner mode, press and hold SET
TIME/PROG for more than 2 seconds to
activate automatic program mode.
» [AUTO] (auto) is displayed.
» The unit automatically stores radio
stationswithsufcientsignalstrength..
» Therstprogrammedradiostationis
broadcast automatically.
Program radio stations
manually
You can program a maximum of 20 preset
radio stations.
1 Tune to a radio station.
2 Press SET TIME/PROG to activate the
program mode.
3 Press / to select a number.
4 Press SET TIME/PROGtoconrm.
5 Repeat the above steps to program other
stations.
Tip
•
To overwrite a programmed station, store
another station in its place.
• To select FM stereo or FM mono, press OK.
Select a preset radio station
1
Press / to select a preset number.
5 Listen to radio
Note
•
Only FM radio reception is available on this
unit.
Tune to a radio station
Tip
•
Position the antenna as far as possible from
TV, VCR or other radiation source.
Note
•
For optimal reception, fully extend and adjust
the position of the antenna.
1 Press TUNER to select FM tuner.
2 Press and hold / for more than 2
seconds.
» [SRCH] (search) is displayed.
» The radio tunes to a station with
strong reception automatically.
3 Repeat step 2 to tune to more stations.
• To tune to a weak station, press
/ repeatedlyuntilyoundoptimal
reception.
Tip
•
[STEREO] is default setting for tuner mode.
• Under tuner mode, you can press OK
repeatedly to toggle between [STEREO] and
[MONO], and the unit memorizes your setting
even if you turn off the unit or turn to other
sources.
EN
DC390_12_UM_Book 1_V5.0.indb 14 12/3/2013 3:11:51 PM