Philips DC612 - Radio Operation; Tuning and Station Selection; Storing Stations on Presets

TUNING TO A STATION
Briefly press the BND key to select the desired waveband:
FM1, FM2, FM3, MW1, MW2, LW, SW
[2] Tune to a radio station using:
Search tuning; Manual tuning; Recalling a preset station; or Auto-Store.
SEARCH TUNING (to quickly search for a station)
[1] Briefly press the ~« key {lower frequency} or i key (higher frequency).
[2] To search for another station, press the same key again.
Note:
[f
the
TA
mode
is
switched
on,
search
tuning
only
selects
stations
which
enable
the
reception
of
Traffic
Announcements.
m= LOCAL / DISTANT (influences search tuning on FM)
© Press the LOC key for at least 2 seconds {until you hear a beep] to switch between LOCAL and
DISTANT mode. {The display shows LOC’ in the LOCAL mode}.
- In LOCAL mode the radio will first search for strong stations and then weaker stations.
— In DISTANT mode the radio will search for any receivable signal (useful in areas with weaker
FM signals).
MANUAL TUNING (if you know the frequency of the required station)
Press the MAN key for at least 2 seconds (until you hear a beep] to switch from search tuning
to manual tuning.
[2]
Tune
to
the
desired
frequency
with
the
~«l
or
B
key
{keeping
the
key
pressed
changes
the
frequency
quickly).
Note: The radio automatically switches back to search tuning (with a beep) after about | minute.
This radio has storage locations for:
(FM3 also used for Auto-store]
({MW22 also used for Auto-store}