Philips DCC 300 - Advanced Recording Settings; General Recording Considerations; Displaying Text Information

4. General
14
Track and time information will not be recorded when
the recording is done in the middle of a blank area on
the tape with the use of the RECORD PAUSE key. A
correction of the tracknumbering with RENUMBER is
not possible (see chapter ‘“RENUMBER’).
To correct possible mistakes on the display, press
RENUMBER key after the last recording (see chapter
‘RENUMBER)’).
|
For a precise record control, reset the tape counter to
‘0000’ by pressing the RESET key.
During ‘RECORD PAUSE’, the unit constantly tests the
input signals. The copy protection is only tested when
‘DIGITAL’ has been selected. If the chosen record
source is copyrighted, recording cannot be started (see
also “TROUBLESHOOTING’).
lf ‘DIGITAL’ has been selected, the unit checks If a
digital source has been connected. If the digital source
is missing1 (e.g. bad cable connection), recording can
not be started.
Text
The text information can only be called with a ‘prerecorded DCC’.
@ lf you press the TEXT key, the display shows for
instance:
@ |f you press the TEXT key again, the display shows for
instance:
@ If you press the TEXT key again, the display shows for
instance:
@ if you press the TEXT key again, the display shows for
instance:
R
-dB 60 50 40 30 2 20 15129 6 4 2 0
-dB 60 50 40 30 2 20 15129 6 4 2 0
-dB 60 50 40 30 2 20 15129 6 4 2 9
R
-dB 60 50 40 30 25 20 15 129 6 4 2 90