Philips DE5205 - Cleaning the Water Tank; Cleaning the Pre-Filter

13EN
5 Allow the pre-lter to air dry
thoroughly before placing back in
the dehumidier.
Note
• To optimize the lifetime of the
pre-lter, make sure it dries
completely after cleaning.
• Wash your hands after handling the
lter.
6 Put the pre-lter back into the
appliance (g.‚).
7 Reattach the rear panel by pressing
the bottom part of the rear panel
onto the appliance rst (1). Then,
gently push the panel against the
body of the appliance (2) (g.g).
8 Put the plug of the dehumidier in
the wall outlet.
9 Touch and hold the timer button
for 3 seconds to reset the pre-lter.
10 Wash your hands thoroughly after
cleaning the lter.
Cleaning the water tank
Clean the water tank every day to keep
it clean.
1 Switch o the dehumidier and
unplug from the electrical outlet.
2 Remove the water tank from the
dehumidier (g.v).
3 Fill the water tank for 1/3 with water
(g.~).
4 Add some mild washing-up liquid
to the water in the water tank.
5 Wash the water tank under a
running tap water, and clean the
insides of it with a soft clean cloth
(g.).
6 Wipe the outside of the water tank
dry with a clean cloth (g.x).
7 Put the water tank back into the
dehumidier (g.y).
Cleaning the pre-lter
Clean the pre-lter when F0 and are
displayed on the screen.
Note
• The pre-lter is washable and
vacuum cleanable.
1 Switch o the dehumidier and
unplug from the electrical outlet.
2 Hold the dehumidier and pull the
top part of the rear cover towards
you (g.c).
3 Detach the pre-lter from the
appliance (g.€).
4 If the pre-lter is very dirty, use a
soft brush to brush away the dust.
Wash the pre-lter under a running
tap water (g.).