84
4
Enter the entire PlusCode number. This number is up to 8 digits
long and can be found next to the start time of the TV program
in your TV listings magazine.
e.g.: 5-234-89 or 5 234 89
Enter 523489 for the PlusCode number.
If you make a mistake, you can clear the entry with CLEAR .
Timer
VCR Plus+ system
PlusCode number
---------
Mo-Fr/Weekly
Press SELECT
To store
Press OK
Selecting daily/weekly recordings
Using SELECT , select from the following options:
'Mo-Fr': Repeated daily recordings from Monday to Friday.
'Weekly': Repeated weekly recordings (every week on the same day).
Tip
5
Confirm with OK .
a The following message appears on the screen: 'Please enter
channel number'
b The channel number of the TV channel has not yet been assigned to
the PlusCode number. Using C , D or the number buttons 0..9 on
the remote control, select the corresponding channel number (name)
of the TV channel and confirm with OK .
a The following message appears on the screen: 'PlusCode
number wrong'
b The entered PlusCode number is incorrect. Repeat your entry or
cancel using the SYSTEM-MENU button.
b Check the time/date (see 'Setting the time & date' in 'Installing your
DVD recorder').
a The following message appears on the screen: 'Date does not
match Mon-Fri'
b A daily recording was entered for the wrong day. Daily programming
can only be used for recordings to be made from Monday to Friday.
Problem
Timer
VCR Plus+ system
Date
01/22
Ch.
001
Start
08:30AM
End
10:00PM
Rec
Mode
M1
To store
Press OK
6
The decoded data appears after confirmation. You can go back
and change the data. Select the appropriate input field with C or
D . Change the information with A , B or the number
buttons 0..9 .
Change 'AM/PM'
Use the SELECT button to select 'AM'or'PM' in the input fields
'Start' and 'End'.
Changing the recording mode
Select 'RecMode' using C .
Using B , A , select the recording mode 'M1, M2, M2x, M3, M4, M6'.
Tip
Programming a recording (TIMER)
To Next Page