41
9 Select the input socket of the DVD recorder to which the receiver is
connected.
a My external receiver is connected only via aerial cable
1 Press O to move to the next page.
Confirm 'Antenna (RF lead)' using OK .
2 Enter the channel number under which the external receiver is stored in
the DVD recorder. (e.g.: channel number 'P 04'). Use the number
buttons 0..9 ,or P- B , P+ A , D , C .
If the external receiver is not allocated to a channel number, you must
search and store it in the DVD recorder as if it were a new TV channel.
Read section 'Search TV channels manually'. Please make sure that the
receiver remains switched on during search and, if necessary, switch it on
to a 'test signal'.
Problem
0 Confirm with OK .
Connecting G;LINK transmitter
The external receiver (satellite receiver, set-top box, cable TV box) is controlled via the DVD
recorder with the G-LINK cable (supplied). This means you can record TV shows that are
received only through the external receiver.
Connection of the G-LINK cable enables the GUIDE Plus+
®
system to show the correct guide
listing.
1 Connect the G-LINK cable to the G-LINK socket at the back of the
DVD recorder.
2 Position the G-LINK transmitter in front of the external receiver so
that the control signal (IR signal) can be transmitted and received by
the receiver unhindered.
How do I find the right position?
If the position of the remote (IR) receiver is indicated on your external
receiver (IR, remote sensor, or such like), place the transmitter about 1 cm in
front of it.
If the position is not indicated, proceed as follows:
1 Switch off the external receiver.
2 Point the remote control at the front of the external receiver.
3 Move the remote control slowly along the front while repeatedly
pressing the on/off button.
4 When the external receiver switches on or off, you've found the
receiver.
5 Attach the G-LINK transmitter about one (1) cm in front of it.
Tip
3 Switch the receiver on and select programme number 02 on the
receiver or using its remote control.
ENGLISH
The GUIDE Plus+® System
To Next Page
Loading...
