65
Timer
ShowView system
Date
01
Prog.
BBC1
Start
20:15
VPS
PDC End
21:30
Rec
Mode
SP
Mo-Fr/Weekly
Press SELECT
To store
Press OK
6 The decoded information appears after confirmation. You can go back
at any time to change the information. Select the appropriate input
field using C or D . If required, change the information using B ,
A or the number buttons 0..9 .
Switching on 'VPS/PDC' in the 'Start' input field
Select the 'Start' input field using C . Using SELECT switch on 'VPS/PDC'
('*' lights up). If you press SELECT again, you will switch 'VPS/PDC' off ('*'
disappears).
Changing the recording quality in the 'End' input field
Select the 'End' input field using C . Using SELECT , select the recording
mode 'HQ, SP+, EP, EP+'.
Tip
7 If all the information is correct, press the OK button. The
programming information is stored in a TIMER block.
8 To end, press TIMER .
9 Load a DVD (unprotected) ready for recording.
The current disc is checked.
0 Switch off with STANDBY m .
The programmed recording will only function properly if the DVD
recorder has been switched off using the STANDBY m button.
If any of the TIMER blocks are in use, 's' will light up on the display.
ENGLISH
Programming a recording (TIMER)
To Next Page
Loading...
