Philips DVDR985 - Initial Setup Procedure; Guided Setup and Configuration

load boot
20504 - Error audio encoder cannot download
test code
20505 - Error audio encoder SRAM WRR cannot
obtain result of test
20506 - Error audio encoder WRR SRAM stuck-
at-zero data bit
20507 - Error audio encoder WRR SRAM stuck-
at-one data bit
20508 - Error audio encoder WRR SRAM data
lines data line x and data line y are connected
20509 - Error audio encoder WRR SRAM illegal
data received
20601 - Error audio encoder interrupt cannot ini-
tialize I2C
20602 - Error audio encoder interrupt cannot
reset DSP through I2C
20603 - Error audio encoder cannot download
test code
20604 - Error occurred accessing VSM
20605 - Audio encoder interrupt not received
20606 - Error occurred while activating the
encoder
20607 - Error audio encoder interrupt cannot ini-
tialize empress
20608 - Error occurred while getting interrupt
reason
20701 - Error audio encoder I2C cannot reset
DSP through I2C
20702 - Error audio encoder cannot download
boot
20703 - Error audio encoder cannot download
TEST code
20704 - Error audio encoder I2C bus busy
20705 - Error audio encoder I2C cannot write
slave address
20706 - Error audio encoder I2C no acknowl-
edgement received
20707 - Error audio encoder I2C cannot
send/receive data
20708 - Error audio encoder received data
through I2C was invalid
20801 - I2C access failed.
20802 - SAA7118 VIP can not be initialized.
20803 - Invalid input
20900 - B1. B2. B3. B4. B5. B6. B7. B8. B9.
B10. B11. B12.
20901 - Firmware download of EMPRESS failed
20902 - I2C bus busy before start
20903 - EMPRESS access time-out
20904 - No acknowledgement from the
EMPRESS
20905 - No data send to the EMPRESS
20906 - No data received from the EMPRESS
30001 - VSM SDRAM Bank1 Memory data bus
test fails.
30002 - VSM SDRAM Bank1 Memory address
bus test fails.
30003 - VSM SDRAM Bank1 Physical memory
device test fails.
30004 - VSM SDRAM Bank2 Memory data bus
test fails.
30005 - VSM SDRAM Bank2 Memory address
bus test fails.
15